Batteries & Chargers

LITHIUM BATTERY NOTICE Please be advised that Rotax lithium batteries are supplied without warranty, either from ourselves or from Rotax. Customers should ensure they are fully informed of the operational requirements and potential risks associated with the use of lithium batteries. If you are uncertain, we strongly recommend the use of a conventional lead-acid battery as a more suitable alternative. Weight: 620g

Read more less

 OPTIMATE LITHIUM Must be used with Rotax Lithium Battery

Read more less

BATTERY YUASAFIT FOR ROTAX EVO

Read more less

BATTERY - EXIDE FIT FOR ROTAX EVO & NON EVO.

Read more less

ROTAX BATTERY CHARGER UK PLUG ADAPTOR

Read more less

ROTAX BATTERY CHARGER

Read more less

Cordless Impact Wrench 3/8"Sq Drive 10.8V 2Ah Amazing bit of kit fit in your karting tool box small and light used to gun on wheel nuts ect...  Model No. CP108VCIW Compact, lightweight cordless impact wrench. • Robust housing with soft grip to reduce vibration. • Integrated LED battery level indicator. • Integrated LED work light. • Supplied with fast charge mains charger and 1 x 2Ah rechargeable Lithium-ion battery. Battery: 10.8V 2Ah Lithium-ion (Included) Consumable Parts: CP108VBP 2Ah Battery Drive: 3/8"Sq Maximum Torque: 120Nm(88lb.ft) No-Load Speed: 0-2700rpm Replacement Parts: CP108VMC - Mains Charger

Read more less

 Optimate1 DUO 12v STD AGM GEL Lithium Battery Charger Motorcycle Motor Bike New! OptiMate 1 Duo features precise microprocessor controlled charging and long term maintenance.Maintain any type of 12 volt lead-acid battery without overcharging, filler cap / wet cell, sealed AGM (MF) or GEL and 12.8/13.2V lithium (LiFePO4) batteries.Ideal for vehicles that are seldom or seasonally used, or in storage.The OptiMate maintenance program delivers only what the battery needs, never overcharges, never undercharges.Cost-effective 12V and Lithium battery maintenance.Charging Amps: 0.6A (constant current)Use: Indoor (lowest temperature: -4°F / -20°C).Save: Low Volt Start of 4VIdeal for: STD, AGM & GEL 12V batteries from 2 – 30Ah and Lithium (LiFePO4) 12.8/13.2V batteries.Input: Global (100-240V 50-60Hz), high efficiency (CEC listed), fully sealed.Style: Dust proof plug-in case, with 12ft / 370cm charge lead ending in SAE connector.Safe: No risk of overcharging.Totally safe for vehicle electronics.Sparks suppressed.Safe for long-term battery maintenance.Automatic shut-down if short-circuited or battery disconnected.3-year limited replacement warranty.Included: O1 weatherproof battery lead & O4 battery clamp lead included.  

Read more less

AIM MYCHRON 5 BATTERY

Read more less

AIM MYCHRON 5 BATTERY CHARGER CABLE

Read more less

SHIDO Lithium batteries offer an excellent level of performance but to gain the best from them, they must be charged correctly. To accommodate the requirements needed we developed our own range of SHIDO battery chargers, suited to motorcycle and Powersport applications. Our SHIDO DC1.0 dual battery chargers come with a unique and optimised algorithm, which allows for a safe charge of both Lithium LiFePO4 and lead-acid batteries. One of the key notices is that charging a deeply discharged Lithium battery (<10V) should be done very gently, starting with applying very low current. Applying high current from the start on discharged Lithium batteries will cause premature failing. Also chargers where the voltage goes above 15 volt for a certain period of time will severely damage your Lithium battery. SHIDO dual chargers will also be maintaining the charge on your batteries after the charging is completed, every 4 hours the charger will check the voltage and when battery voltage drops below 12,8 volts, the charger will start applying charge once again. Suitable for 6V and 12V batteries Specific AGM mode for sealed batteries Clear split between Lithium and lead-acid charging modes Upgraded algorithm for both Lithium and lead-acid modes Battery Recovery for deeply discharged batteries Battery health check after charging Maintaining mode, with 4 hour interval voltage checks Protected against reverse polarity, overcharging, overheating and short-circuits  

Read more less

  The OptiMate 2 smart charger-maintainer is the most cost-effective solution for long term maintenance of 12V batteries in any vehicle / craft that is stored in or outdoors. OptiMate 2 is also ideal for standby power applications - the interactive standby mode during long-term maintenance reverts to full charge mode if it senses high current drain from the battery. How It Works 1. Battery check: OptiMate 2 must be connected to a battery (retaining a minimum of 2V) to activate its output. 2. Bulk charge stage: Charges at 0.8 Amps constant current to efficiently bring the battery up to 14.3V. 3. Verification stage: Immediately follows bulk charge mode during which the battery's ability to accept a charge and thereafter its charged status is verified. A battery in poor health unable to hold a charge is indicated by the yellow charge LED alternating with the green maintain LED every 3 seconds. For a battery that appears healthy the voltage is limited at 13.6V for 30 minutes while the circuit monitors the actual voltage and the current absorbed by the battery, during which the green maintain LED remains on. If during the 30 minutes the automatic circuit senses the battery requires further charging, the program reverts to bulk charge infrequently until a full charge is achieved. 4. Maintenance / float charge stage: consists of 30-minute float charge periods followed by 30-minute ‘rest’ periods during which there is no charge current. This alternating “50% duty cycle” prevents loss of electrolyte in sealed batteries and minimizes gradual loss of water from the electrolyte in batteries with filler caps, and thereby contributes significantly to optimising the service life of irregularly or seasonally used batteries. During the 30-minute charge period the circuit offers current to the battery within a safe 13.6V voltage limit (“float charge”) allowing it to draw whatever small current is necessary to sustain it at (or close to) full charge and compensate for any small electrical loads imposed by connected circuitry, or the natural gradual self-discharge of the battery itself. During the 30-minute rest period the battery voltage is monitored. For a good battery the green maintain LED should remain on. The program will return to bulk charge if the battery voltage cannot remain above the test level during the rest period. 5. Interactive standby: A load that causes the battery voltage to suddenly reduce will return the program to Bulk charge mode. After the battery has been recharged the program returns to the maintenance charge & rest cycle. OptiMate 2 can remain connected to the battery indefinitely - the battery will remain cool and safe. And optimally charged. Of course.  

Read more less

ROTAX BATTERY CHARGER - OXIMISER 90 ANNIVERSARY Designed to auto mantain, optimise & prolong the life of your battery.Provides real time info on battery condition. Heavily discharged batteries as low as 4.1V can be charged. Suitable for all 12V batteries up tp 30ah. 

Read more less

ROTAX BATTERY CHARGER - OXIMISER 900Designed to auto mantain, optimise & prolong the life of your battery.Provides real time info on battery condition. Heavily discharged batteries as low as 4.1V can be charged. Suitable for all 12V batteries up tp 30ah. 

Read more less

AIM MYCHRON 5 BATTERY CHARGER DOCK

Read more less